210 Industrial Dr., Arlington Wisconsin 53911 | When I restored the 1937 Fairbanks Moorse two cylinder for our Badger Steam and Gas
club at Baraboo Wi I had the original air tanks tested for thickness and than approved by
the State boiler inspector. They are over twice the thickness of new modern tanks and the
inspector said the older riveted tanks are even better. I need 175psi and 200psi is even better
to start the engine and have them bolted down solid to be safe. I even use the original air
compressor
 (IMG_1152 (full).JPG)
Attachments
----------------
 IMG_1152 (full).JPG (143KB - 34 downloads)
|
What a good use for this?
