Near Intersection of I-35 & I-90 Southern Mn. | EZ-Boom follows the standard Raven Pinout on the 16 Pin Connector. There is a post down aways that gives this Pinout for a '496 cable. The first Boom Triggers are as follows:
Pin 6 is Boom 1
Pin 2 is Boom 2
Pin 5 is Boom 3
Pin 7 is Boom 4
Pin 8 is Boom 5
You would also need ground to the boom valves. It is quite likely that you would need +12V also in the case of motorized ball valves.
Here are some other pins that you apparently are not going to use:
Pin 11 is Flowmeter Ground
Pin 12 is Flowmeter +5V
Pin 13 is Flowmeter Signal
Pin 3 & Pin 4 are the Inc/Dec Pair for a Standard Motorized Control Valve.
Pin 1 is chassis Ground and Pin 16 is +12V. Note these wires will only be Power and Ground if a Raven Console cable is used and the large wires are connected to the battery.
Edited by tedbear 3/25/2009 03:39
|