Near Intersection of I-35 & I-90 Southern Mn. | Gerard - 3/23/2009 20:06
Maybe you can use the implement switch harness for the GS2.
I am not familiar with the Deere Implement switch but I have done this type of thing with EZ-Guides.
It is safest to use a relay so as not to introduce power back into the Deere device. If the Deere harness has two wires for an implement switch, I would attach them to the Normally Open and Common terminals of a relay.
Use the Raven Orange/white wire and the pure white wire to the coil of the relay. When the Raven Master switch is ON, the Orange/white wire will have 12V on it. The white wire is ground. Then when the Raven Master is ON, the relay should close and connect the Deere wires together.
If the action works but is "backwards" you may need to use a SPDT relay that also has a Normally Closed terminal. Hooking the Deere wires to the Common and Normally Closed terminal will reverse the results. |
turning mapping on/off on GS2 with Raven master switch
