Winkler, Manitoba Canada | jbweston - 4/7/2020 14:40
When doing a planter hydraulic drive test in barn hard, I cannot get simulated speed to go above 3 mph. I try to change it, type in a new number of use the up and down arrows, and it reverts back to 3 mph.
What am I doing wrong? Drives are turning.
Not sure what you are doing. Our 20/20 automatically does a low speed test and a high speed test.
Go to Setup/Diagnosis/Rowflow/Health Check/Motor Stability to check the drive/motor. |
20/20 and Row Flow simulated speed problem
