Thought I would share a couple of ideals on how we built are trailer about six years ago. We used E-track in the center of trailer for tying totes down. So far the track stays clean enough from dirt. We just blow it out once a season. The thing I like about the track system is I can tie things down anywhere and not have it be a tipping hazard when not in use. The other thing we did is installed all three of the cone inductors on a frame with a 12-volt actuator. We installed the small bubble next to the switch so we can level out quickly for road slope. We went this route so we don't have to worry about meters being calibrated for each product or using the scale system where you need to figure weight.
(17904 (full).jpeg)
(17905 (full).jpeg)
(17906 (full).jpeg)
Attachments ---------------- 17904 (full).jpeg (232KB - 440 downloads) 17905 (full).jpeg (202KB - 435 downloads) 17906 (full).jpeg (117KB - 402 downloads)
|