|
Sibley County, MN | I've got one of these, https://www.ebay.com/itm/12V-100psi-Fit-Fuel-Oil-Air-Water-Pressure-...
Do not have it installed yet, so I can't tell you if it works like it should. You need to enter the correct calibration value for your sensor though. The sensor linked above needs 40mV entered in your system. 4000 mV range / 100 psi = 40 mV
DirectCommand supports up to 3 digital pressure sensors per liquid system, produced by the following brands: Ag Leader, Dickey-John and Raven.
To calibrate the pressure sensor, two factors are needed: pressure set point and voltage/pressure ratio.
Pressure Set Point- Enter the pressure set point in psi (we recommend doing this at true zero pressure) or compare off an analog gauge.
Voltage/Pressure Ratio- Enter the voltage/pressure ratio which is a constant per pressure sensor brand. Values are 16mV for Ag Leader and Raven and 45mV for Dickey John. | |
|