AgTalk Home
AgTalk Home
Search Forums | Classifieds (45) | Skins | Language
You are logged in as a guest. ( logon | register )

Case 3340 not holding rate
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Hogsforever
Posted 3/26/2020 19:08 (#8141262 - in reply to #8141109)
Subject: RE: Case 3340 not holding rate


N. Illinois
Sounds good. I don’t run stream bars but use the bypass system to side dress 32%. Don’t run orifices. I use the tip size as my orifice. Your pressure will be regulated by the rate you enter and the pump will adjust for your speed. Set the min/max pressure you want too. I like the flex system. It’s alot jammed into one monitor though. My one piece of advice is really pay attention to your task controller when you first start a field. Ensure that it’s mapping. If it’s not you might double up herbicide. Make sure you start a task!
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)