I have run my SDX 40 Air seeder with a pro 600.  It controls the implement only and not connected to any other can bus on the tractor as it is a JD 9400T.  The 9400T is auto steered with a mojo RTK radio and base and then I feed NEMA data from that with a null modem cable to my pro 600 and everything works.  I recently acquired a pro 700 and installed that but cannot get the gps to work for mapping.  It is set up the same as I can tell except that under Toolbox/GPS the set up screen looks different than on the Pro 600.  RS232B is selected and it is seeing all of the satellites in the diagnostic page on the GPS2 tab but on the GPS tab it just says GPS-Status Wait-0 and all of the other boxes are not showing anything for heading, Pdop, Hdop, Etc.  Is the pro 700 missing some software or something else?  I have a call in but have no answers yet. The last picture a screenshot of my pro 600.

(1F3D1E2B-D7E3-4A3B-9A46-93DFD9B61C04 (full).jpeg)

(94A21270-7A47-43C7-AC47-8F406273AEA5 (full).jpeg)

(E2747E58-6B02-46B5-96BA-C9ED84035C3B (full).jpeg)

(F299F1CE-135E-4CFE-8E47-2D8805C3A098 (full).jpeg)

(C206D9EB-1FF3-4A38-AED6-8F008DE96D1E (full).jpeg)

1F3D1E2B-D7E3-4A3B-9A46-93DFD9B61C04 (full).jpeg (20KB - 117 downloads)

94A21270-7A47-43C7-AC47-8F406273AEA5 (full).jpeg (17KB - 115 downloads)

E2747E58-6B02-46B5-96BA-C9ED84035C3B (full).jpeg (16KB - 109 downloads)

F299F1CE-135E-4CFE-8E47-2D8805C3A098 (full).jpeg (14KB - 123 downloads)

C206D9EB-1FF3-4A38-AED6-8F008DE96D1E (full).jpeg (18KB - 115 downloads)