|
SW Ohio | I have a pull type sprayer that I have just setup with a liquid product module. I have got it setup and running good through my IC800.
Now that I have it up and running like I want I am going to add a fence row nozzle.
I have a Hypro ProStop-E valve that I want to use for my fence row nozzle. It requires power, ground and signal. The kit came with a little switch box to control it but I would rather use my incommand.
I have 6 boom sections and a 7 section cable. I want to use the unused section for my fence row nozzle.
I want it to be set-up in the display as a fence row nozzle, not as a 7th section. I remember reading that I could accomplish this by moving a pin in the connector.
I am looking for direction on what pin needs moved where.
Thanks! | |
|