|
Terril, IA | As long as you arent doing any sort of ag leader steering this will work with ag express cable part number: AE3070B. This cable tees into the John Deere Harness at the roof where the receiver plugs in. Then runs a 9 pin serial cable to the inside of the cable that will hook into your InCommand display cable's GPS port. From there you will want to go onto your Deere display and set that baud rate and Hz rate. Usually 38400 baud and 10 Hz rate works well. Then enable the following NMEA messages GGA, VTG, GSA. This should be everything to supply GPS to you InCommand 1200. | |
|