210 Industrial Dr., Arlington Wisconsin 53911 | Make sure its set right. Should be on low for corn high for beans and than set sensitivity knob when planting
to 2 or 3 o'clock position than slowly back it down to 10-11 o'clock position until lights go out than one more
division usually around 9 or 10 o'clock. If still not right make sure no corroded connections or cut harness and
make sure sensors not dirty or clouded from seeds hitting them. Take them out and take a good look at the eyes.
Scrub with soapy water and if eyes clouded replace them. Your local Deere dealer should have a monitor tester
to check the box. I find most problems with the harness or bad seed sensors. |