|
| A non-AI drift reduction tip.... *Cough* Wilger *Cough* lol
For actual helpful tip, a good way of cleaning is using a heated ultra-sonic cleaner. It is super good if you have a lot of residue building up inside/around tip exit orifices too (works great on stainless too). Don't turn the heat up too much, but I doubt you'd be able to melt any of the plastics used in making tips. (Or at least I'd hope not).
Think we have one or two of them around the shop that we bought for like $120 CDN a few years ago.
Edited by WilgerIndustries 5/28/2019 11:51
| |
|
Which air induction nozzles are easiest to clean?
