|
Canyon, TX | Call Leica and ask for ISO D- Remote Engage Switch part #675695AG All the Mojo's we Install on MT's we include this switch, no one wants to reach up there to engage.
You can also use the factory installed Auto Guide Switch if it is already there, and use a wire harness with the correct Iso D-plug into the back of the Console.
We are using the same switch to turn on the coverage Mapping on a GS 2 2600 display in a MT that we have the Mojo steering the MT and bringing Nmea from the Mojo cable #675559AG to the GS2 for Rate control on strip till rigs for several customers
As far as Midwestag's question from above, please see attached photo's of MOJO steering CAT MT835B sending NMEA to GS2 display for mapping, etc. Pulling Orthman 16 row 30" 1RipR using Mojo's new Pivot Software from the console. It is repeating 1" on full section pivots in West TX.
Edited by DW78 1/31/2009 17:29
(102_0409.JPG)
(102_0420.JPG)
(IMG_0048.jpg)
(IMG_0049.jpg)
(IMG_0050.jpg)
(102_0423.JPG)
(102_0424.JPG)
(IMG_0044.jpg)
(IMG_0042.jpg)
(IMG_0041.jpg)
Attachments ---------------- 102_0409.JPG (118KB - 106 downloads) 102_0420.JPG (108KB - 115 downloads) IMG_0048.jpg (65KB - 103 downloads) IMG_0049.jpg (48KB - 103 downloads) IMG_0050.jpg (49KB - 104 downloads) 102_0423.JPG (126KB - 101 downloads) 102_0424.JPG (106KB - 97 downloads) IMG_0044.jpg (59KB - 114 downloads) IMG_0042.jpg (51KB - 99 downloads) IMG_0041.jpg (26KB - 101 downloads)
| |
|