AgTalk Home
AgTalk Home
Search Forums | Classifieds (81) | Skins | Language
You are logged in as a guest. ( logon | register )

The clip for JD nameplate? (4620)
View previous thread :: View next thread
   Forums List -> Where Can I find?????Message format
 
Sodbustr
Posted 12/5/2018 18:06 (#7151185 - in reply to #7150621)
Subject: RE: The clip for JD nameplate? (4620)


Western Iowa
If it is OEM it takes a 1/4" 'push nut'

The aftermarket raised letter ones used to take 3/16", but I haven't done a set for a few years, so it sure could have changed.

They make a few different styles, some are round, some are rectangular, but they all work the same, just push on over the stud. You can get them at most supply stores I would think. Our local Bomgaars store has them.....

Edited by Sodbustr 12/5/2018 18:07




(iu (full).jpg)



(4-6 (full).jpg)



Attachments
----------------
Attachments iu (full).jpg (13KB - 4 downloads)
Attachments 4-6 (full).jpg (4KB - 2 downloads)
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)