|
| Well, we got it working. Come to find out, the internal and external harness as provided by AGCO does not include a switched 12v feed. Therefore, the C1000 would not power up without this. I got a plug wiring diagram from the planter manual and added this switched wire to the correct port, ran through the external harness and pinned in the AMP connector for the fender. Inside, I used an old Trimble power harness to T into the front power socket and draw the switched feed from there, pinning into the AMP plug. The pin location on the square plug that goes into the console is #2 for the switched feed.
This brought the console to life. I then hooked up to the planter and the second console brought up the planter program as expected.
Hopefully someone can get some use out of this at some point.
Appreciate the help and suggestions I received. | |
|