|
IA | No it won't, eventually the outer most ubolt on your 10bolt hubs will work loose and then so will the rest of the bolts, which will ruin the keyway on the axle and the cast key in the hub. I went through this on a 8050, what I ended up doing was cutting the inside ubolt section of the hub off and just running with 2 bolts which actually held Better because there was no hub sticking out past the end of the axle. Only issue there was the duals wouldn't run down 30 inch rows. If you really want to run axle mount 10 bolt hubs, I would find a set of longer axles and switch them out then the 10 bolt hubs will work great. | |
|