Francesville, IN | Trimble 372 uses standard Trimble Receiver Wiring, can be found in User Manual (Attached) main pins used for serial communication is 2,3,5, and power is on 10, 11, if CAN is going though this harness then you need 1,12, and if Autopilot is in this harness need all plus PPS on pin 4.
 (372_PortA (full).PNG)
 (372_PortB (full).PNG)
Attachments
----------------
 372_PortA (full).PNG (76KB - 37 downloads)
372_PortB (full).PNG (51KB - 38 downloads)
|
CNH Cell Modem Wire Harness Diagram
