Near Intersection of I-35 & I-90 Southern Mn. | KMech - 5/30/2017 20:00
Verify your speed input settings for the monitor module, and also the row spacing. An incorrect row spacing can cause an incorrect population, but indicated spacing will remain accurate.
I would agree. With a new module, you may have created a new configuration with some incorrect settings.
If using ground drive, the system must "know" what population you are shooting for. This is to set the 100% level for the population bar graph. Possibly this is not agreement with your actual desired rate. In other words, if the bar graph settings was set for 100,000/acre but your ground drive was set for 130,000, the bar graph would seem to indicate over planting. Pushing the wrench beside the bar graph will allow you to type in the population for the 100% level.
Edited by tedbear 5/31/2017 07:46
|