|
SE MN | You need to take the plastic housing off and switch the guts so your sprocket is on the correct side. Take the sprocket off. Take the small Phillips screw out the side of the housing, turn housing counter clockwise and remove cover. Remove other half of housing, switch the guts around and reassemble. The insides should all stay together in the right order if you leave the snap ring on. If these clutches are used you may want to take the snap ring off and clean the insides before putting them back togrther. We converted some pull row clutches on a Kinze to push rows by doing this and worked fine. | |
|
Tru count clutches
