South Georgia | BacNBlak - 5/25/2016 20:55
Wow, so it actually CRASHED to the ground? Not a forced, controlled landing?
I like the fact that our P3's have that safety feature but it makes me uneasy too at the same time. I like to have control so that way if something like this happens, at least I can blame myself.
Yep, it crashed. I was just about to land it when it decided to take over and go home. Went up to its hover, sat there a sec and started its forward move towards the take off point. I would say it went 20 ft and dropped suddenly but recovered, then it started falling fast. Hit the dirt hard, with three motors locked down and smoking. Bad part is, it would not shut off.
The first two pictures are two different motors screws that hold them in, they melted out. 3 of the motors sit crooked now cause the plastic melted.
Pics 3 and 4 are the coils in the motors. Suppose to be shiney copper coloring, now 3 are black , burnt looking. I still say it is odd that the motor that didn't burn up was one of the ones against the dirt after it crashed.
Edited by GAFarmer55 5/25/2016 22:20
 (image.jpeg)
 (image.jpeg)
 (image.jpeg)
 (image.jpeg)
Attachments
----------------
 image.jpeg (59KB - 489 downloads)
image.jpeg (69KB - 526 downloads)
image.jpeg (75KB - 484 downloads)
image.jpeg (91KB - 480 downloads)
|
DJI Phantom 3 Pro Problem
