|
MN | There are two parts to the harness there is the cab portion of the greenstar harness and the implement harness. Where they hook up there is a four pin connector and 2 two pin connectors. Make sure both of the two pin connectors are hooked up. Pin F out of the greenstar display sends out a 5volt signal on wire #209. This signal goes through the cab harness to the two pin connector and plugs into the implement harness, the end of that wire is at the implement connector. The connector you are plugging into at the back of the cab should be the one in the implement harness. You can check resistance from the greenstar display connector pin F to the white wire out back to make sure there is continuity, If there isnt its probably not hooked up between the two harnesses. Also check the pins on the greenstar display I have seen a few with pins bent to the side. | |
|