I drilled a 1/8" hole through a plate on the house. I wanted to run a telephone wire in from outside. I drilled it at an angle so it came out below the siding. However when I got the better cable it won't fit through the hole. I need to make the hole slightly larger.
I can't use a regular short bit as it won't reach. The bit I originally used was about 12" long. I don't want to use my 3/8" bit and have a big hole to fill. I can't get at the bottom hole from inside or outside as out side is too close to the ground and inside is below everything.
Because the holes are so far apart I can't egg them out with the long 1/8" bit.
(hole.jpg)
Attachments ---------------- hole.jpg (17KB - 85 downloads)
|