|
Northeast Nebraska | 40' flatbed trailer that I stripped completely, sandblasted, painted, re-wired and put in new floor.
Replaced the tires and wheels with 22.5s to open up my used tire options.
I put half wore virgin tires on it. 4000 gallon tank. 3" plumbing. All full port.
1600 gallon gooseneck trailer that I did the same too. Replaced brakes and wheel bearings and tires.
Did some new plumbing. 2" for the pump and ad 3" fill on the back. There is a tank that hasnt showed up yet for on the tongue.
It will be only 17" tall and hold 110 gallons. I will use it for powermax.
It will gravity feed into the cone and thats what I will use to measure it out.
This trailer is only going to get used when its not efficient to chase to a field with a semi.
Finally is the sprayer knee bushings. I'm working on it right now.
I'm replacing the spindles because of wear.
It took me and my brother 3 hours start to where it is now. Used the skid loader to help lift.
Edited by dewgubbe 3/5/2012 23:48
(40' Side.jpg)
(40' Rear.jpg)
(40' Floor.jpg)
(GN Front Side.jpg)
(GN Side.jpg)
(GN Rear.jpg)
(Wheel Motor Front.jpg)
(Wheel Motor Side.jpg)
Attachments ---------------- 40' Side.jpg (43KB - 259 downloads) 40' Rear.jpg (53KB - 281 downloads) 40' Floor.jpg (45KB - 263 downloads) GN Front Side.jpg (61KB - 278 downloads) GN Side.jpg (49KB - 291 downloads) GN Rear.jpg (29KB - 274 downloads) Wheel Motor Front.jpg (45KB - 290 downloads) Wheel Motor Side.jpg (40KB - 272 downloads)
| |
|