AgTalk Home
AgTalk Home
Search Forums | Classifieds (54) | Skins | Language
You are logged in as a guest. ( logon | register )

Adam,building scraper 23
View previous thread :: View next thread
   Forums List -> Stock TalkMessage format
 
Skipper
Posted 2/23/2012 20:55 (#2247453 - in reply to #2247438)
Subject: Re: Adam,building scraper 23



801486 - 2/23/2012 19:49

leaving the two wheels separate so you could use spacers on one of the cylinders to tilt the blade. I don't know if that would work or not or if you would need to be able to lock the wheels together when you wanted it to run level. Any opinions?


Ours has a common main axle that raises both wheels together. One of the wheels pivots off of this common frame. It will stay set at whatever angle throught the raise and lower functions. I'm thinking that is the best way to achieve the tilt. It can be tilted right and left. Ours also has a weight box on the frame ------that stays full. One addition I would make to ours would be those scarficer(sp) shanks.

I like Adams axle setup. Its a LOT beefer than ours.

Edited by Skipper 2/23/2012 21:01
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)