|
SE Nebraska | I have drawn some parts on a cad program for an excavator thumb and would like to get them cut out. The steel is one inch thick and the longest piece is 50 inches long. I am thinking plasma cut for cost and precision. Some pin holes will be cut out so I don't know if flame cut would be accurate enough and laser might cost quite a bit more. A local shop was going to send it to Sioux city for me, but has not had time. I need a place with low set up cost as I have five different profiles and ten parts total.
Anyone know of a place close to southeast Nebraska that could handle the job, or the name of the shop in Sioux city? | |
|