|
South Africa | The firmware version you have is causing this. The reason for this is so that you can not reset the different sprayer section withs from 'not all the same' to 'all the same' when you change the width. I will recommend that you save the current vehicle configuration for the vehicle it is setup correctly for. Then you go to Spanner, Application control, and when you choose your controller type, it should run through the implement setup automatically. You may be able to change the width at the boom setup as well, also under Application control.
Setup each of the implements, and save each implement/vehicle configuration under Data Management. Restore each applicable configuration as you need them. Then the complete vehicle/implement setup is done.
These setup is all done in Advanced mode. | |
|