|
Bainville, MT | It has been my experience that a GS2 controls reads and logs only what is occurring in the raven. A simple way to check this would be to look at the target and actual rate on the GS2 and compare that to the rate that is being display on the Raven.
Basically setup a home page that has target and actual rate on it. The target rate is whatever you have programed in on Rate 1 and Rate 2 of the Raven unless of course you are using a prescription. Applied or actual is what rate is actually coming out of the machine ( when it logs back to the GS2, it logs without display rate smoothing). Now if target and actual are the same as what the raven say's it does not change anything. Which it doesn't change anything. There is however a slight delay at displaying logged rate.
Mike | |
|
GS2 and Raven 440
