|
| Manual for the FMX display is the worst manual I have seen. It doesn't explain anything, it about time for trimble to get there head out of the ass.
I had imported boundaries to my FMX Display when it was version 2.0 from AFS Software 9.5. We have now upgraded the FMX to 3.0. Problem is when u start a field the status item of Field Area and Productive Area have to total area of the field before we start spraying. When we are done with the field both status items have been doubled in value. It seems to be making a new boundary over the old one. Does anyone know why this would happen? I tried deleting the field and importing them again, but its seems that Version 3.0 for the FMX is not compatible with version 9.5 of the AFS Software. And who want to type them in again in the data dictionary. When we start the field we make a a new headland with these settings. Boundaries: Enabled, Infill Boundary: outer, Headland: 1
the areas right when we are done are the event coverage areas.
Don’t have any these problems with Pro 600 it is by far the superior monitor | |
|
Any answers for this
