|
| Not 2 difficult, about an 6hour install if you have never done one and want to do it right and neat.
AgLeader T's into header sensor, elevator speed sensor, & ground speed sensor. Probably one thing that scares everybody is cutting holes in side of clean grain elevator to mount Elevator mount unit for AgLeader moisture sensor.
AgLeader will not use JD's moisture bazooka nor will they use there flow potentiometer. Bazooka can be unpluged so 70 command center doesn't bark at you and flow poteniometer will be removed and AgLeader flow sensor (load cell) will be put in its place. By far better sensor as well.
AgLeader you run all new cables to everything and with new AgLeader monitors (Insight & Edge) you mount modules on the machine for can bus system. Sometimes (although rare) there might be a starfire gps on the machine already and AgLeader can use the starfire to get gps with the right agleader cable.
My opinon is a little bias, but I think it is by far a better yield montitoring system than JD's.
bo42ku | |
|
time to switch JD 9770 to ag leader yield monitor?
