The first picture shows the RAM bracket that I drilled and mounted to the corner post.  The second shows the RAM arm that I use, it moves the EZ-Guide 500 far enough out of the corner, it measures about 7 3/4" center to center on the ball mounts.

 I built the mount for the T2, it stays secure when you remove the T2 so that when you reinstall it the roll cal should be very close if you have saved the configuration.  The roll cal is relatively easy to do again so maybe that is not that big of an advantage.

(EZbracketJDcombine4.jpg)

(EZbracketJDcombine5.jpg)

EZbracketJDcombine4.jpg (55KB - 363 downloads)

EZbracketJDcombine5.jpg (60KB - 385 downloads)