|
Hendricks MN | Trimble is not isobus. They can run some isobus implements but are not isobus. If you could get the firmware and software it probably could be done. Trimble will not give there software out. If you go to http://www.dickey-john.com/product/intelliag-with-trimble-auto-pilo... and click on Technical Information at the bottom of the page you will see.
Trimble Autopilot™ steering system distributed by DICKEY-john will only interface and operate with an IntelliAg® system that includes the DICKEY-john A1 Plus 10 inch terminal.
All Autopilot vehicle platform kits will be shipped with a Navigation Controller pre-loaded with specific IntelliAg firmware and an adaptor cable that allows connection of the Navigation Controller to the IntelliAg CAN system power harness.
You need a dickey-john A1 plus IntellAg preloaded with auto pilot and a nav controller preloaded with IntelliAg firmware. | |
|