Middlesex County, Ontario | The foot switch connects to the T2 for EZ steer, it needs a db25 connector. The foot switches that you see with a Deutsch connector are for EZ Pilot.
The foot switch will plug into the un-used 25 pin connector on the T2 and will connect pins 10 and 11 when depressed, leave pins 10/11 open when released. If you would prefer a toggle switch in your arm rest you can make your harness with any momentary switch and by cutting up a parallel port extension cable, using a db25 plug with screw terminals, or soldering small wires into a db25 connector. I have made several cables like this.
You will have to change the ez steer engage settings to "remote engage."
Edited by WildBuckwheat 1/23/2023 14:16
|