Both sides of the Mason-Dixon Line | Wednesday evening I was helping a customer calibrate the GS1 yield mapping system in his 9610. When the operator pressed the start button to start recording the calibration load, the monitor recorded 150 lbs even though we had not started cutting. The combine was completely cleaned out prior to pressing the start button. If this were an Ag Leader I would adjust the vibration calibration but I don't think the GS1 has that ability. Is it safe to disconnect the flow sensor in order to see if that is where the erroneous weight readings are coming from? Any other ideas/experiences to share? thanks |
GS1 records yield w/o grainflow
