|
| Just put a bunch of those parts in my 9660. My left side bolt was broke. Upon further inspection after removing the chaffer, the frame was cracked in front of the hole where the bolt attaches it to the arm. After further disassembly, the front shaker pan under the precleaner that the two side pieces of the chaffer frame bolts to was getting busted up too. I replaced the two shaker arms on both sides along with the green arm that goes back from the eccentric bearing and drives the chaffer/upper shaker pan. Needed to remove the chopper to get the chaffer frame out. Be sure and get it timed and torqued properly when reassembling. The new two arms from the eccentric bearing are much much stronger.
Nothing about $6200 in parts could not cure. And a run to North American parts distribution center in Quad cities area on Sat afternoon. Three days of repair work. All the labor was me and my brothers. I do have a right side chaffer frame rail that appears to be intact if it would help. | |
|