|
East Helena Montana | I know this is an older post and you may have found answers already.
Are you looking for the pinout of the connector X901 between the combine and header or elsewhere?
If you are looking for the pinout info for connector X901 which is the 31 pin round connector that plugs into your header here is what the service manual shows.
Pin 1 circuit 416- left ultra sonic sensor
Pin 2 circuit 417 - right ultrasonic sensor
Pin3 circuit 414- header height sensor #3
Pin 4 circuit 021/016- electric power/control power
Pin 5 circuit 413- header height sensor #2
Pin 6 circuit 415- header height sensor #4
Pin 7 circuit 412- header height sensor #1
Pin8 circuit 608- reel speed signal
Pin 9 circuit 454- header height sensor #5
Pin10 circuit 480- height sensor ground
Pin 11 blank
Pin 12 circuit 10- ground
Pin 13 circuit 515- left turn
Pin 14 circuit 514- right turn
Pin 15 circuit 529- stubble light
Pin 16 circuit- 436- front end select 8
Pin 17 circuit 488- Front end select 2
Pin 18 circuit 489- front end select 1
Pin 19 circuit 497- Hydraflex diverter valve
Pin 20 circuit 481- height sensor power
Pin 21 blank
Pin 22 blank
Pin 23 blank
Pin 24 blank
Pin 25 blank
Pin 26 circuit 455- draper speed increase
Pin 27 circuit 456- draper speed decrease
Pin 28 Circuit 457 Front end select
Pin 29 blank
Pin 30 circuit 835- reel height sensor
Pin 31 circuit 834- reel fore/aft sensor
Im sure some of these options are not in North America but its what the book list.
Jeff | |
|
Deere 9650STS head connector wiring pinout
