I have gotten a couple e-mails about how I hooked my RC in to my 854 so I thought I would post a reply for everyone to see. It took me a little while to get everything set correctly in the GS2 and to find out how to have the valves set and mow I am very happy with the set up and do not like spraying without it. I had to make my own harness to adapt the RC to the wiring for my Raven 460 but with the pin out provided in the RC OM and a copy of the Raven pinout it was very easy, I will try to find the sheet that I wrote the pinout on to make the harness this evening. The GS2 settings I am running are:

Section Valve Type:  3-wire 

Controller Valve Type:   Fast

Control Valve cal:   313

Flowmeter cal:   64

Feel free to add to this or ask any questions.

This is the plug that plugs into the back of the 460.

This is the plug out of the RC.

This is the harness that I had to make.

THis is the 460 end of the harnes that I had to make.

This is the RC end of the harness that I made.

This is the mess of wires you end up with in the cab, but it is well worth it.