AgTalk Home
AgTalk Home
Search Forums | Classifieds (50) | Skins | Language
You are logged in as a guest. ( logon | register )

About Agleader Rate Application module
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
tedbear
Posted 10/15/2021 05:38 (#9269709 - in reply to #9268090)
Subject: RE: About Agleader Rate Application module


Near Intersection of I-35 & I-90 Southern Mn.
jpucheu - 10/14/2021 07:02

Hi! Does this module have an ISOBUS version? (from ag-leader or another manufacturer)
I need something similar to log coverage in different isobus tractors, but monitoring the application rate would be very useful.
Thanks
Juan



Not to my knowledge unless something new has come along. The Application Rate Module can be connected to an Ag Leader CAN display with the usual round CAN connector. It can be used a few different ways. 1) by using an implement switch or relay from another device, coverage mapping can be controlled In other words a coverage map is turned ON when an implement is in the working position 2) It can connect to a flow meter or shaft sensor. Then a rate map can be created. This map starts/stops based on sensor activity. This setup is for monitoring of an entire implement only. There is no provision for sections or rate control. 3) By means of a special serial cable the Application Rate Module can be connected to various 3rd party devices such as a Raven 440. In this situation, the two devices interchange information. This allows the Ag Leader to display a rate map and allows the Ag Leader to "send" rates to the Raven. Auto section control is not supported.

Yet another choice is to allow one to connect an outside speed source such as a radar gun to the system.

I am not aware of a method to tie into the ISOBUS with my Application Rate Module.

Edited by tedbear 10/15/2021 05:40
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)