|
| Neighbor came by today to borrow coils off flex pressure valve on right side of header. Claims his machine will not raise up into rigid mode.
Went with him, hydraflex side of valve magnetizes but header doesn't react. We swaped them around and the reel circuit make the header react.
OK, so either at that point we have a weak coil, stuck valve, or low voltage, but coil does energize.
Meanwhile, in the cab, hydraflex pressure is stuck on a number in the 345x's, a number that shouldn't be, I have never seen higher than 2900 or so, and doesn't change even when we used the reel circuit to go from flex to rigid.
NOTE: He did blow out that panel in the engine compartment last week and everything worked fine before!!!!!
Any thoughts here?? | |
|
JD 9760 having hydraflex issues
