|
Carter Montana | Check your flowmeter calibration setting and make sure it has been set to the tag on the flowmeter.
Verify your flow control is working by listening to it on full manual with everything shut off. Go to full manual, make sure autoswath is unchecked, and make sure you have good flow through the flow meter.
Ag Leader had me check the cabling by setting my flowmeter to 1 and check my cabling by jumping across two of the wires on the flow meter cable (they will have to tell you which two as I can't remember which.) Their support just keeps on being excellent with these kinds of issues.
I had the exact same problem and if it isn't the flowmeter calibration number it's almost certainly something with that cable. My problems were of my own making as I didn't realize Raven flow sensor and pressure sensors are wired different. I needed a short extension for my application and used the wrong one.
It's a long story covered in an earlier thread............. | |
|
Insight Direct command no flowmeter recognized
