|
central iowa | I just hooked up Insight DC system, and while it will spray, we are not getting any flow reading. It will spray fine standing still (using the minimum flow setting), but it wont read flow or gallons. I am guessing when we actually try to spray it is not going to work either. This setup is using the complete harness replacing a Raven 440. I have checked the flow meter for junk and it spins freely, I have also reflashed the modules with the new firmware and the insight also has the latest. I am sure I have just missed something simple, but cannot figure it out.
I have tried making a new configuration, and that has not helped either.
Any Ideas appreciated
Kirk
| |
|
Insight Direct command no flowmeter recognized
