AgTalk Home
AgTalk Home
Search Forums | Classifieds (42) | Skins | Language
You are logged in as a guest. ( logon | register )

Calibrating Direct Command on sprayer
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
DevinF
Posted 4/18/2007 12:59 (#138872)
Subject: Calibrating Direct Command on sprayer



Nwmo
I got the DC setup on our JD 6500. I am using a new raven 60 series flow meter and the tab says the cal number is 700. For DC I divide that by 10 to get 70 and that is the number I put into the console. My question is if DC has any calibration mode that lets me fine tune that meter cal number. I'm not sure that its off from what it should be. I have just sprayed water in the barn lot and according to the water level gauge it is off but it could have been sitting unleveled.

I didn't see anywhere in the setup guide or on the insight that looked like a meter calibration. Just wondering how you guys do it if you do at all.

Thanks,
Devin Ferguson
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)