|
Ripley ONT... | I check in to add a E.pressure sensor...raven number 422-0000-090=237.00$....I am going set my Fast valve the same as John did...I had the same Problem when I was running SC, I would loss pressure on the headlands when it saw a piece unsprayed... These are the pin numbers for the gs2 rate controller
Pin 31=pressure signal=c
pin 30=pressure 5v=b
pin 29=ground= a
ps. since we manipulate the valve control to be open at 20 psi will we get enough volume at 30galons++ for applying 28?
I had no problem applying 28 at high galons with sc. just running into the problem with 10 galon ranges.
 (rogator (Medium).jpg)
 (P6120290 (Medium).jpg)
 (P6120291 (Medium).jpg)
 (P6120292 (Medium).jpg)
 (P6120293 (Medium).jpg)
 (P6120294 (Medium).jpg)
 (P6120295 (Medium).jpg)
 (P6120296 (Medium).jpg)
 (P6120297 (Medium).jpg)
 (P6120298 (Medium).jpg)
 (P6120300 (Medium).jpg)
Attachments
----------------
 rogator (Medium).jpg (69KB - 749 downloads)
P6120290 (Medium).jpg (40KB - 712 downloads)
P6120291 (Medium).jpg (97KB - 719 downloads)
P6120292 (Medium).jpg (87KB - 748 downloads)
P6120293 (Medium).jpg (57KB - 737 downloads)
P6120294 (Medium).jpg (61KB - 706 downloads)
P6120295 (Medium).jpg (31KB - 714 downloads)
P6120296 (Medium).jpg (49KB - 775 downloads)
P6120297 (Medium).jpg (76KB - 739 downloads)
P6120298 (Medium).jpg (38KB - 722 downloads)
P6120300 (Medium).jpg (44KB - 755 downloads)
| |
|
JD Rate Controller in Rogator 854 answers
