|
| I ran lexions for 25 years and decided to try a new x9. So not that familiar with Deere combines. On my lexions you could set header height and auto contour would work no matter how many times you raised and lowered the header until you cut the header drive off. On this new X9 after you set number 2 on header height, if you raise the header slightly the auto contour quits working even if you drop the header back down. Then you have to hit number 2 again to make auto contour work. With the 16 row head I need for the auto contour to work all the time especially when crossing washouts. Is this the way Deere works? Or do I have to do something in settings to get the auto contour to work all the time when raising and lowering back down in uneven ground like the lexion | |
|
Header height auto contour on new x9 drops off when raising the header slightly
