|
NW KS | I will have to poke around a little more. So far I haven't been able to determine much about the 9 pin connector in the photo. Pins 2,3, and 5 are populated which would be a standard rs232 setup. You are fairly sure that was the connector that went to the old field star printer? That is a bunch of message in show in the service bulletin. It would be nice to have the yield monitor on the rtk receiver but it may turn into more of a project than I anticipated. Either way thanks for the info. Field star documentation can be hard to come by. | |
|
Gleaner/fieldstar 2 yield monitor GPS
