|
Central ND | I keep intermittently getting the error that the smart connector cant supply 8V to the sensors and to do a module reset. When the error shows up I loose all sensor values and fieldview even quits recording. After reset it will work for a bit and then repeat. No set time it takes for it to happen but has gotten more frequent as the day went on towards the end. I'm using a Gen 1 display using the latest firmware with a Gen 2 smart connector. I've done some reading on here and a few have mentioned seed sensors starting to go bad causing something similiar. Anything else to try or look at? Will be digging into it in the morning. Have unplugged and replugged things in. When the error happens I still have 9V at the 3 RUMs and over 13V at the smart connector. Have about 600 acres left.
Edited by case 5/26/2018 19:05
| |
|
|