|
| We are running a Insight/Autopilot on a soybean planter with implement switch. I am trying to add a ppm module to do planter monitoring. I can't get the configuration to accept an implement switch and ppm at the same time. It doesn't ask for an imp switch at setup.
There are 3 plugs that come out of my ppm. One goes to the planter seed tube harness, one plugs into the 12v power plug from tractor, the last one goes to the can node from tractor. I left the app rate module hooked up the same- can node from tractor harness to "can bus", imp switch plugs into the "aux" pigtail, "comm" plug on module is unused.
Do you guys think this is correct? (probably should try to post a pic) | |
|