|
Arco MN | Have surVac clutches with Agleader clutch control module, run everything with Integra.
Worked good for 5 or 6 years and quit working last year for some reason in soybeans.
Imagine that they don't work again this year.
When testing the cylinoid moves in and out and it clicks like they always used to.
Problem is they don't stop the seed flow. They try and the Integra shows it turning the clutches off but the seed slow never stops and you can visually see it still planting in the air when testing.
What's the issue? Also using PP east disks ina 7300 JD planter.
Checks the high current and its got 13+volts to the module.
The little pads that run on the disk don't look to groves up but could that be the issue?
Nay on run into this before?
Edited by Noble1 4/24/2017 18:53
| |
|