|
NCND | So we have never had an issue with being on for an entire field say if we are applying 5gpa will end at 4.9-5 on the whole field avg. this year with all screens clean and non restricting I keep getting 4.4-4.5.
Sprayed some 10gpa stuff other day and it was coming back 9.4gpa.
I haven't changed a thing what's up?
I did notice in the job summaries it had different numbers also where it showed I applied a higher GPa rate than what it showed in the field data.
Ive noticed that as sections come on the rate drops and stays lower a little longer than normal.
I did pick up a new flow meter but haven't got to run it yet.
Do I have an actual flow meter problem or computer not talking properly, issues? Everything updated on gs3/sprayer side of things.
I've recalibrated pump and pressure sensor. Speed source is GPS. Just trying to figure out what is causing the issues. My money is on flow meter as it spins freely but when it comes to stop it doesn't coast so much as a sudden stop all though it's from a slow speed. Doesn't seem quite right.
Thanks | |
|
|