|
West-Central Missouri | I need to replace the aluminum housing on a meter from a 7200 Deere planter. This is a vacuum meter with ESET discs. How do I remove this bushing that holds the spring in the first pic. I assume it just drives off as there appears to be no snap ring groove or roll pin hole on the new housing. Is it glued in with a retaining compound?
2nd pic is the new aluminum housing where the bushing goes.
(image (full).jpg)
(image (full).jpg)
Attachments ---------------- image (full).jpg (88KB - 166 downloads) image (full).jpg (104KB - 120 downloads)
| |
|