|
| To configure the nanostations, you'll first want to make sure you know what subnet your Airport is using, simply type in ipconfig into command prompt and take note of the IPV4 Address. It may be 192.168.0.XXX or 192.168.1.xxx or something else. When you set up your radios, you'll want to assign them static IP's in the same subnet, basically meaning that the first three numbering groups are identical. Ex, If your subnet is 192.168.0.xxx, you want to assign your radios IP addresses in the range of 192.168.0.2-192.168.0.254.
Next, turn any wifi off, and connect a powered on nanostation directly from the power block to the ethernet port on your PC. These come factory with an address of 192.168.1.20, so you want to assign your PC a static IP address of 192.168.1.100. These are good instructions on setting a static IP.
http://www.howtogeek.com/howto/19249/how-to-assign-a-static-ip-addr...
Don't worry about setting DNS, it doesn't matter in this case. Just IP and subnet mask. Once set up, you'll be able to type in 192.168.1.20 into your browser and access the nanostation setup page.
Crosstalk solutions has great videos on setting these up, follow these instructions will help too.
https://www.youtube.com/watch?v=wZxJPBukjbY
| |
|
Setting up Ubiquiti Nanostations to Connect to Aiport Extreme
